Dylan Banera

WorkMotocross

Sheet 10 of 22

Dirt bike control covers

Handlebar control covers for a dirt bike, modelled in Fusion, printed and fitted on the bike.

Date
Mar 2026
Media
7 photos
CAD
Autodesk Fusion
Disciplines
MotocrossCAD3D Printing
Fig. 01Three covers printed in green, two with the KOKO logo in a second colourEnlarge

Notes

The Fusion files are named "Kill switch cover v2" and "3 button cover v1". Each cover is a small block with side tabs and a cut-out underneath. Some versions carry the number 77 on top, others the KOKO logo.

One set was printed in green, two of its covers with the KOKO logo in a second colour. On the bike, a paddle-shaped cover sits beside the front brake lever and a square one is on the bar.

Photos

6 figures

Fig. 02The kill switch cover in Fusion, with the number 77 on top
Fig. 03Render of the kill switch cover with the number 77 on top
Fig. 04Render of the paddle-shaped cover with KOKO lettering
Fig. 05Render of the hex-shaped cover with the full KOKO logo
Fig. 06A cover beside the front brake lever
Fig. 07A square cover on the handlebar