Dylan Banera

Work3D Printed Parts

Sheet 20 of 22

3D-printed putter head

A mallet putter I modelled in Fusion 360, with a 3D-printed head.

Media
4 photos
Software
Fusion 360
Disciplines
3D PrintingCAD
Fig. 01The full putter, head and shaft, in Fusion 360Enlarge

Notes

I modelled this mallet putter in Fusion 360: the head body with two prongs at the back on its own, and the full putter with a hosel and shaft.

The head was 3D printed in plain black, and layer lines show on its left end. In the last two photos it sits beside a finished putter with the same two-prong layout.

Photos

3 figures

Fig. 02The head body on its own in Fusion 360, without the hosel
Fig. 03The printed head (left) beside a finished putter with the same two-prong layout
Fig. 04The same two heads from another angle, showing the prongs