Dylan Banera

WorkMotocross

Sheet 06 of 22

Printed triple clamps

Upper and lower triple clamps for a dual-crown fork, modelled in Fusion, printed and assembled.

Date
Jun 2026
Media
4 photos · 2 videos
CAD
Autodesk Fusion
Disciplines
Motocross3D PrintingCAD
Fig. 01The printed upper and lower clampsEnlarge

Notes

In Fusion, the two clamps are modelled as a pair on the steerer tube, with split clamps around the fork legs and pockets in the top faces.

The clamps were printed in black, layer lines still showing, then assembled onto the fork legs and steerer with the fork caps fitted.

Photos and videos

5 figures

Fig. 02Both clamps on the steerer in Fusion
Fig. 03The clamps from below in Fusion
Fig. 04The clamps assembled on the fork
Clip 0:06
Fig. 05The assembled fork standing on the shop floor
Clip 0:03
Fig. 06Close-up of the top clamp and fork caps